Hello,
When I was examining my LPM3.5 program with low power mode, suddenly I got an error message trying to rewrite that program. My tools are MSP-EXP432P401R, MSP432P401R Rev:C, XDS100v2, CCSv6.2.0. This trouble has been caused twice.
The error massage is as bellow.
I cricked the Toggle RST, but got the following error message.
I cricked the Reset and got the following error message.
I did power-cycles the board and tried the Factory Reset, the connecting was success but Factory Reset resulted in the same failed. But MSP-FET could rewrite the device briefly, after then XDS100v2 can write the device.
Is using MSP-FET only the method for recovering?
Best regards,
Kazuo Yamauchi