Part Number:MSP430I2020
Hello,
My customer can not write to Flash Memory that using MSP-GANG programmer.
The combination they're using.
PC - USB - MSP-GANG - Splitter - (MSP-TS430RHB32A - MSP430i2020) x 6
They could write up to four in Flash.
They fail to write if they are more than 5 in Flash.
I doubted the power supply.
However, in the manual, "supply current from Vcc during erase ... 13 mA max" is stated.
There are 6 devices, total is 78 mA.
MSP-GANG can also supply enough.
(Is the higher power consumption during writing?)
How should it be done to make writing in succeed?
Regards, DA