Part Number:MSP430FR2632
Hello,
I'm using the MSP430FR2632 and would like to program the firmware using the bsl scripter. The uart is connected to a usb controller (FTDI chip). When I program the device using the bsl scripter after calling BSL from software application, all works fine! But when I have an empty device (RESET VECTOR = empty) I'm not able to program the device with the bsl scripter! An empthy reset vector should invokes the BSL if I'm right.
When I send a MASS ERASE I got no response. I perform the programming within the 10 seconds before the device goes into LPM4!
What should I do? Thanks, Ronald