Hello,
My customer is plannning to debug MSP432 with SWD(Serial Wire Debug) protocol.
His environment is
MSP432(customboard) + MSP-FET + MSP-FET-432ADPTR + CCSv6.3
We know MSP-FET supports SWD from here.
store.ti.com/msp-fet.aspx
"Supports ARM JTAG and ARM SWD debug protocols"
but we cat't find how to configure to use SDW in CCS.
Seeing this document,
www.ti.com/.../slau597b.pdf
P40 "5 FAQ"
if you select XDS110 in Target Configuration, you can set SWD Mode.
but we want to use MSP-FET for SWD.
Could you show me how to configure to use SDW in CCS ?
And what signals should be pulled out from his MSP432(customboard) for MSP-FET SWD ?
Regards,
Takeshi Matsuzaki.