Part Number:MSP-EXP430F5529LP
Tool/software: Code Composer Studio
Hi All,
I cannot get GUI Composer to run in an example project.
I have a MSP-EXP430F5529LP and TRF7970ABP bundle I am using to evaluate RFID product options. I have successfully programmed and can debug the example code sloa227 for the RFID Reader/Writer. I have followed the directions in the NFCLink Standalone Getting Started guide to the "section 2.4 Install the MSP430 CDC Driver" . When the MSP430/TRF7970 kit is connected and running in CCS7, the new com ports that are enumerated according to the WIn Device Manager are: "MSP Application UART1", "MSP Debug Interface", and "USB Serial Device". There is no "MSP-USB Example". as described in the Getting Started Guide.
I do not understand whether the CDC driver is installed, or whether the LP application is incorrect, or whether I just do not understand the next step. After many hours of looking at posts and trying to understand the differences between CGv1 and GCv2, etc. I just do not get what the next step should be. I have used GC in the past with CCS 6.
I have the opened the GUI Composer from View/Gui Composer is CCS but get lost on next step.
How do I determine and/or load the "NFCLink (standalone firmware) in the target?
As is obvious I lack the basic understanding of how the pieces of software should be installed and what functions each provides. I would greatly appreciate any guidance I can get. I have lots of TIVA, CCS, and a little GUI Composer work in the past but am stuck here.
Thanks,
Randy